Konica Minolta FK-102 - Manual (Page 318)

FAX terms - (continued)
Appendix-10
G
■ G3
One of the fax communication modes standardized by ITU-T. There are G3 and G4 in the
communication mode. G3 is the most used communication mode now.
■ Group dialing
To group multiple abbreviated numbers. It is useful if you frequently use the sequential multiple
station transmission or the polling reception. You can register up to 200 abbreviated numbers
in a group.
H
■ Horizontal scanning
The horizontal direction when the original is scanned.
I
■ ID Tx
The function to send fax with a password. Sender has to send a fax with the same password
which is set in Closed area Rx if the Closed area Rx is set at the recipient.
■ Int'l com
The international communication. In Int'l com mode, a lower transmission rate will be
employed. Select this mode if you send a fax to the location at which the communication con-
dition is poor even if it is in your country.
L
■ Long original
The function to transmit pages longer than the length (420 mm/16.5 inch) of 11 x 17 size. If
you attempt to send such a long document without selecting Long original mode, paper mis-
feed will occur. When Long original mode is selected, pages of up to 800 mm can be transmit-
ted.
M
■ Manual transmission
This operation to send documents while confirming the status of the receiving machine.
■ Memory
The location to store data. It is used to specify the communication or store the document.
■ Memory overflow
The state of the fax image memory in this machine to be full during storing transmitted docu-
ment.