Konica Minolta FK-102 - Manual (Page 321)

FAX terms - (continued)
Appendix-13
Appendix
T
■ Telbook
To dial the remote station by searching the name of the remote station from the list of the
abbreviated dial numbers registered.
■ Timer Tx
The function to specify the time to start communication. You can save costs by specifying a
transmission to start at midnight or early in the morning during which telephone charges are
less.
■ Total page set
The function to place the total number of pages on each page of the fax in quick memory
transmission. It is useful for the recipient to make sure whether all pages of the fax have been
sent or not (the total number of pages are automatically placed in memory transmission).
■ Transmission rates
The transmission rates of the modem in the facsimile. It can transmit in high-speed 33,600
bps. If it is set to Int'l com mode, it transmits in noise-resistant 7,200 bps or 4,800 bps.
■ Transmission time
The time to send a fax. The higher resolution is, the longer it takes to transmit.
U
■ Upside down
The function to specify the appropriate binding style when transmitting a two-sided document
(i.e., when pages are printed on both sides). The binding style you select should allow the
pages of a two-sided document to be read appropriately by paging right to left or top to bot-
tom.
V
■ V34
The communication mode under the super G3 fax communication. It may not be possible to
communicate in super G3 mode if the receiver or sender is connected to the line via an exten-
sion exchange equipment.
■ Vertical scanning
The vertical direction when the original is scanned.
Z
■ Z folded original
The function to determine the document sizes before reading and sending the original. Some
facsimiles cannot detect the document size if it has been folded. This function is available only
when reading the original with the RADF.