ElmoMC SimplIQ Digital Servo Drives-Harmonica Installation Guide - Manual (Page 16)

Harmonica Installation Guide Installation
MAN-HARIG (Ver. 1.902)
www.elmomc.com
16
Component Connector Described
in Section
Drawing
Motor data sheet or manual
3.2. Unpacking the Drive Components
Before you begin working with the Harmonica system, verify that you have all of its
components, as follows:
•
The Harmonica servo drive
• The Composer software and software manual
• The Harmonica cable kit (if ordered separately)
The Harmonica is shipped in a cardboard box with Styrofoam protection.
To unpack the Harmonica:
1. Carefully remove the servo drive from the box and the Styrofoam.
2. Check the drive to ensure that there is no visible damage to the instrument. If any damage
has occurred, report it immediately to the carrier that delivered your drive.
3. To ensure that the Harmonica you have unpacked is the appropriate type for your
requirements, locate the part number sticker on the side of the Harmonica. It looks like
this:
2