EUCHNER AS-i 3.0 PROFIBUS Gateway with integrated Safety Monitor for 2 AS-i circuits - Manual (Page 160)

160 Subject to reasonable modifications due to technical advances Id.-No.: 103329 Issue date - 24.10.2008 EUCHNER GmbH + Co. KG
Kohlhammerstraße 16 • D-70771 Leinfelden-Echterdingen Tel. +49/711/75 97-0 • Fax. +49/711/753316
AS-i 3.0 PROFIBUS Gateway with integrated Safety Monitor
Appendix: Example for startup on a Siemens S7
ExtDiag on Peripheral Faults
Activates and deactivates setting of the ExtDiag flag on peripheral faults.
Default: Setting of the ExtDiag flag on peripheral faults disabled.
ExtDiag on Earth Fault
Activates and deactivates setting of the ExtDiag flag on earth (ground) fault.
Default: Setting of the ExtDiag flag on earth fault is disabled.
ExtDiag on Double Address
Activates and deactivates setting of the ExtDiag flag on double address.
Default: Setting of the ExtDiag flag on double address is disabled.
Freeze Diagnosis
The diagnostic data are continuously updated during runtime. If this is not de-
sired, this parameter can be used to disable continuous updating. Updating then
takes place only when this is required by the PROFIBUS standard.
AS-i Input Change Buffers
Default: Disabled.
Download Slave Parameters
Based on this entry the parameter bits can be downloaded for each AS-i slave.
These are then sent to the connected AS-i slave when the AS-i cycle is started.
Sending of the set parameters bits can be disabled with this value.
Default: Sending of the AS-i parameter bits enabled.
AS-i-Parameter Slave 1/1A...