EUCHNER AS-i 3.0 PROFIBUS Gateway with integrated Safety Monitor for 2 AS-i circuits - Manual (Page 87)

AS-i 3.0 PROFIBUS Gateway with integrated Safety Monitor
Operation in advanced display mod
Subject to reasonable modifications due to technical advances Id.-No.: 103329 Issue date - 24.10.2008 EUCHNER GmbH + Co. KG 87
Kohlhammerstraße 16 • D-70771 Leinfelden-Echterdingen Tel. +49/711/75 97-0 • Fax. +49/711/753316
The safety code sequences are replaced by the following values:
Both channels are in the safe state: 0000bin
Channel 1 is in the safe state: 0011bin
Channel 2 is in the safe state: 1100bin
No channel is in the safe state: 1111bin
NO SUBSTITUTE
The safety code sequences are transmitted via the input data.
9.6 DIAGNOSTICS
Main menu || DIAGNOSIS ||
This menu contains the following sub-menus:
For additional information refer to chap. <Advanced Diagnostics for AS-i Mas-
ters>.
SAFETY SLAVES
INT MONITOR
EXT MONITOR
FAULT DETECTOR
DELTA LIST
LCS
ERROR COUNTERS
LPF
FLAGS
ACTUAL CONFIG
AS-I MASTER
SAFETY SLAVES: Safety input slaves
INT MONITOR: Display the diagnosis data for the integrated Safety Monitor
EXT MONITOR: Display the diagnosis data for the external Safety Monitors
FAULT DETECTOR: Informations about the AS-i Fault Detector
DELTA LIST: List of AS-i slaves with configuration error
LCS: List of slaves having caused a configuration error
ERROR COUNTERS: Fault counter for each single AS-i slave
LPF: List of Peripheral Faults
FLAGS: Display of the EC-Flags
ACTUAL CONFIG: Display of the current configuration
AS-I MASTER: Display of the software states