EUCHNER AS-i 3.0 PROFIBUS Gateway with integrated Safety Monitor for 2 AS-i circuits - Manual (Page 171)

AS-i 3.0 PROFIBUS Gateway with integrated Safety Monitor
Appendix: Example for startup on a Siemens S7
Subject to reasonable modifications due to technical advances Id.-No.: 103329 Issue date - 24.10.2008 EUCHNER GmbH + Co. KG 171
Kohlhammerstraße 16 • D-70771 Leinfelden-Echterdingen Tel. +49/711/75 97-0 • Fax. +49/711/753316
If for timing reasons an AS-i error must be responded to in a non-interrupt control-
led way, the message can be turned off using the ExtDiag flag. In this case it is
sufficient to check the AS-i flag Config Error in the program sequence.
The same applies to the other messages.
If the message for various error states of the AS-i 3.0 PROFIBUS Gateway with
integrated Safety Monitor is activated via the PROFIBUS and if the data for the
PROFIBUS diagnostic data are enabled, the SIEMENS function module SFC13
can be used to retrieve the PROFIBUS diagnostic data of the AS-i Gateway and
save them to a data module. Use of SFC13 is described in detail in the SIEMENS
documentation for PROFIBUS.