Lenze E94AYFLF Digital frequency module - Manual (Page 10)

Digital frequency extension module | Parameter setting & configuration
Digital frequency input
Parameter setting
10
L
EDS94AYFLF EN 3.2 - 10/2010
2.2 Parameter setting
Short overview of the parameters for the digital frequency input:

Note!
Depending on the module receptacle the digital frequency extension module is
plugged in, different code ranges are assigned to the parameters!
• Module receptacle MXI1: Parameters are in the C130xx range
• Module receptacle MXI2: Parameters are in the C140xx range
Parameter Info Lenze setting
  Value Unit
C13010 C14010 Encoder type DFIN Digital frequency output DFOUT
C13011 C14011 No. of increments DFIN 2048
C13012 C14012 Signal form DFIN 4x evaluation (A, B)
C13013 C14013 Initialisation time DFIN 3000 ms
C13014 C14014 Track monitoring DFIN Active after initialisation time
C13021 C14021 TP delay time DFIN 0 μs
C13030 C14030 Speed at DFIN - Incr./ms
C13031 C14031 Frequency at DFIN - Hz
C13032 C14032 Position at DFIN - Increments
C13040 C14040 Resp. to track monitoring DFIN Warning
C13041 C14041 No resp. to DFIN enable signal Warning
C13042 C14042 Resp. to Vcc error DFIN Warning
 Digital frequency extension module in module receptacle MXI1
 Digital frequency extension module in module receptacle MXI2
Greyed out = display parameter