Lenze E94AYFLF Digital frequency module - Manual (Page 18)

Digital frequency extension module | Parameter setting & configuration
Digital frequency input
System block "LS_DigitalFrequencyInput"
18
L
EDS94AYFLF EN 3.2 - 10/2010
2.4 System block "LS_DigitalFrequencyInput"
The system block LS_DigitalFrequencyInput displays the optional digital frequency
extension module in the FB editor of the »Engineer«.
 The system block must be called cyclically since only then speed and position will be
calculated accurately to increments.
Inputs
Input
Data type
Info/possible settings
DFIN_bLoadReferencePos
BOOL
Position setting
 Position setting ( 12)
FALSEÊTRUE Sets the 32-bit absolute position output at the output
DFIN_dnActualPos_p to the value which is applied to input
DFIN_dnReferencePos_p.
DFIN_dnReferencePos_p
DINT
Absolute position in [increments], to which the output DFIN_dnActualPos_p is set by
a FALSE-TRUE edge at input DFIN_bLoadReferencePos.
 Position setting ( 12)
DFIN_AxisData
V3.0 or higher
Machine parameters
• To transfer the machine parameters of the drive/motor, connect this input to the
output DI_AxisData of SB LS_DriveInterface.
• The machine parameters of a higher-level drive can be transferred via the
FB L_SdSetAxisData. For this purpose, you have to connect the FB's AxisData
output to this input.
• If the input remains unused, the system block continues to operate as before. In
this case the units are scaled to revolutions.
 Use of machine parameters for scaling ( 13)
/6B'LJLWDO)UHTXHQF\,QSXW
'),1BE/RDG5HIHUHQFH3RV
'),1BGQ5HIHUHQFH3RVBS
'),1BGQ$FWXDO3RVBS
'),1BGQ$FWXDO6SHHGBV
'),1BE9FF&WUO/LPLWHG
'),1BE6HQVH
'),1BE7UDFN$(UURU
'),1BE7UDFN%(UURU
'),1BE7UDFN=(UURU
;
'),1B$[LV'DWD