Metal Sales T-Armor Series - Manual (Page 45)

© Metal Sales Manufacturing Corporation / Subject to change without notice 09/14
45
T-ARMOR
Factory-Notched Panels - Metal Sales can provide factory-notched panel ends to eliminate material build up or reliance on
field-notching for weathertight seams at panel endlaps.
One panel - Eave to Peak
Two or more panels - Eave to Peak
Standard Panel
Eave Eave
Peak Peak
Peak Panel
Mid Panel
Eave Panel
DESIGN / INSTALLATION CONSIDERATIONS (
cont
.)
STANDARD PANEL (Not Notched):
X Used when field-cut panels are required
X Used as an Peak panel for endlaps
X One panel from eave to peak of roof
X No notching
X 'L' is the Order Length: 80' max length, 6' min length
EAVE NOTCHED PANEL:
X Used when endlapping of panels is not required
X Used when field cut panels is not required
X One panel from eave to peak of roof
X Eave notching for hemming the panel
X 'L' is the Order Length : 80' max length, 6' min length
ENDLAP NOTCHED PANEL:
X Used when endlapping of panels is required but panels will
not be hemmed
X Used as mid panel of endlapping run
X Notched for panel endlapping
X 'L' is the Order Length : 80' max length, 6' min length
EAVE & ENDLAP NOTCHED PANEL:
X Used when endlapping of panels is required and panels will
be hemmed
X Notched for panel endlapping
X Eave notching for hemming the panel
X 'L' is the Order Length : 80' max length, 6' min length
CAP END NOTCHING:
X Used to be turned down at the eave
X Used for End Laps
X Used to tuck under high side flashings
X 'L' is the Order Length : 80' max length, 6' min length
*Note eave turn down not recommended in high snow or high debris areas
L
L
L
Cap
L
2"
3"
1 1 /
2
"
1 1 /
2
"
3"
L