Step 1, T-armor – Metal Sales T-Armor Series User Manual
Page 47
© Metal Sales Manufacturing Corporation / Subject to change without notice 09/14
47
T-ARMOR
INSTALLING
PANEL CLIP
STEP
1
Floating Rake Angle
Eave Flashing
Offset Cleat
Roof Cleat
Offset Rake Slide
Deck Screw (1'-0" oc)
Offset Cleat
Double Bead Tape Sealant
Moisture Barrier (by others)
Eave
Roof Cleat
Fasteners (by others)
INSTALLATION OF PANEL
INSTALLING EAVE FLASHING
Steps:
1. Install cleat and fastening into roof framing with fasteners 1'-0" oc.
2. Hook Eave flashing onto the Cleat and temporarily fasten into place.
3. Install continuous row of Double Bead Tape Sealant across the top of the Eave flashing.
4. Install Offset Cleat at Double Bead Tape Sealant and use #14-13 Deck Screws 1'-0" oc to fasten to the roof.
5. If two or more Eave flashings are required lap the flashing over the previously installed flashing by a minimum of 2"
placing two beads of Tube Sealant between the flashings and secure with Pop Rivets 2.5" oc.