Metal Sales T-Armor Series - Manual (Page 62)

© Metal Sales Manufacturing Corporation / Subject to change without notice 09/14
T-ARMOR
62
ENDLAP
INSTALLATION NOTES
Note: Panel Endlaps must be staggered a minimum of
24" and must be hand crimped before seaming.
1. Once the Eave Panel has been installed, apply two rows of
Endlap Pad (see page 51) across flat pan of the panel.
2. Apply a bead of Tube Sealant across each Endlap Pad
and up both vertical ribs.
3. Set the Peak Panel into place and nest with Eave Panel
so that the 3" factory notch is completely covered. (See
page 51 for complete details on installing endlapped
panels.)
4. Apply a bead of Tube Sealant at the butted ends of the
panel hems. Insert Stiffener Plate into butted panel hems
and set in the Tube Sealant.
5. Apply 2.5" Pig Tail of Endlap Pad and wrap around top of panel at butted ends, contacting Tube Sealant on the
panel rib.
6. Use a C-Clamp to hold panels in place. Drill hole and install 9 /
32
" Bulb-Tite Rivets (see page 52 for number of
fasteners and order).
7. Install Eave Cap, apply a bead of Tube Sealant across the width of the end of the notch and install the Peak
Cap. The Cap endlap must be located a minimum of 12" away from the panel endlap.
9 /
32
" Bulb-Tite Rivet (see page 52)
Stiffening Plate (set in Tube Sealant)
T-Armor Panel
Endlap Pad (2 Rows Set in the Pan) (see page 51)
Panel Clip w/ (2) #14-13 Deck Screws
T-Armor Panel (Factory-Notched for Endlap)
Pig Tail (Wrap Around Top of Panel at
Butted Ends of end lap)
Tube Sealant
Stiffener Plate
Panel Cap (Factory-Notched)
2 Rows of Tube Sealant (Across the
Pan and up Both Ribs)
Panel Clip w/ (2) #14-13 Deck Screws
Bearing Plate
9 /
32
" Bulb-Tite Rivet (see page 52) A
A
3"
9" max
12"
1 /
2
:12 Slope
Minimum
*Can only be used with the
low and high clip systems
Metal Decking (By others)
Section A-A T-Armor Panel
3 /
4
"x4" Stiffener Plate 16 Ga.
2.5" Pig Tail (Wrap Around
Top of Panel at Butted Ends)
Panel Cap