Metal Sales T-Armor Series - Manual (Page 66)

© Metal Sales Manufacturing Corporation / Subject to change without notice 09/14
T-ARMOR
66
ENDWALL - FIXED
INSTALLATION NOTES
1. Install Eave Plate and fasten through wood blocking and
into metal deck with #14-13 Deck Screws at 1'-0" oc. If
more than one Eave Plate is required then butt the ends
together.
2. Place panels on to the Eave Plate and apply a row of
Double Bead Tape Sealant across panel, up and over all
ribs approximately 2" to3" from panel end.
3. Field-cut Z-Closure to fit between the panel ribs, install
Z-Closure over Tape Sealant. Before continuing make
sure Z-Closure placement will accommodate Pitch Break.
4. Once Z-Closure is set in Tape Sealant, fasten through
Z-Closure, Tape Sealant, T-Armor panel and into the
Eave Plate with #12-14x1" Self Driller N/W screws (see
page 75 for number and location of fasteners required).
5. Install Pitch Break by applying Double Bead Tape
Sealant to the top of the Z-Closure and hooking the open
hem around the Z-Closure. Fasten into the wall substrate with fasteners at 1'-0" oc maximum.
6. If two or more flashings are required, lap the flashing over the previously installed flashing by a minimum of
2" placing a bead of Tube Sealant between the flashings and secure with Pop Rivets, 2.5" oc.
7. Install Counter Flashing, Reglet, or wall panel and fasten to parapet wall with appropriate fastener, 1'-0" oc. If
Counter Flashing or Reglet is used, seal at wall with Tube Sealant.
Tube Sealant
Fastener (by others)
Counter Flashing
Moisture Barrier (by others)
Starter
Pitch Break
Panel Turn Up
Double Bead Tape Sealant
#12-14x1" SD N/W (1 per rib)
Z-Closure (see Pg 75)
#14-13 Deck Screws (1'-0" oc)
Clip w/(2) #14-13 Deck Screws
#12-14x1" SD N/W (see Pg 75)
Eave Plate
Bearing Plate
1 /
2
:12 Slope
Minimum
Wood Blocking
Metal Decking (By others)
With Reglet
With Counter
12" max
Additional #14-13 Deck
Screws may be required for
areas with large snow loads
*Panel cap not shown for clarity