Blade ICE RACKSWITCH G8124-E - Manual (Page 288)

BLADEOS 6.5.2 Application Guide
288 Chapter 20: OSPF BMD00220, October 2010
OSPFv2 Configuration Examples
A summary of the basic steps for configuring OSPF on the G8124 is listed here. Detailed
instructions for each of the steps is covered in the following sections:
1. Configure IP interfaces.
One IP interface is required for each desired network (range of IP addresses) being assigned to an
OSPF area on the switch.
2. (Optional) Configure the router ID.
The router ID is required only when configuring virtual links on the switch.
3. Enable OSPF on the switch.
4. Define the OSPF areas.
5. Configure OSPF interface parameters.
IP interfaces are used for attaching networks to the various areas.
6. (Optional) Configure route summarization between OSPF areas.
7. (Optional) Configure virtual links.
8. (Optional) Configure host routes.