Blade ICE RACKSWITCH G8124-E - Manual (Page 374)

BLADEOS 6.5.2 Application Guide
374 Chapter 27: Remote Monitoring BMD00220, October 2010
RMON Group 9—Events
The RMON Event Group allows you to define events that are triggered by alarms. An event can be
a log message, an SNMP trap, or both.
When an alarm is generated, it triggers a corresponding event notification. Use the following
commands to correlate an Event index to an alarm:
RMON events use SNMP and syslogs to send notifications. Therefore, an SNMP trap host must be
configured for trap event notification to work properly.
RMON uses a syslog host to send syslog messages. Therefore, an existing syslog host must be
configured for event log notification to work properly. Each log event generates a syslog of type
RMON that corresponds to the event.
For example, to configure the RMON event parameters.
This configuration creates an RMON event that sends a syslog message each time it is triggered by
an alarm.
RS G8124(config)# rmon alarm <alarm number> rising-crossing-index
<event number>
RS G8124(config)# rmon alarm <alarm number> falling-crossing-index
<event number>
RS G8124(config)# rmon event 110 type log
RS G8124(config)# rmon event 110 description "SYSLOG_this_alarm"
RS G8124(config)# rmon event 110 owner "log icmpInEchos alarm"