Rockwell Automation 1512A MV Controllers, 400A One-High Cabinet, Standard and Arc-Resistant Enclosure User Manual
Page 40
Advertising
32
Rockwell Automation Publication 1512A-UM100F-EN-P - May 2013
Chapter 4
Common Installation
2. Connect the incoming power lines to the power bus. Torque to
specifications (refer to
Recommended Torque Values on page 2 of
) (see
).
Figure 37 - Incoming Line Cable Connections
3. Connect the ground wire to the ground bus lug.
4. Connect any external control wires to the control panel terminal blocks in
the low voltage compartment. Refer to wiring diagram.
Power
Cable
Lugs
Ground
Bus
Lug
IMPORTANT
If line cables require installation by front access, complete the incoming line
connection before installing load cables.
Advertising