Rockwell Automation 1788-EN2DN Ethernet-to-DeviceNet Linking Device - Manual (Page 12)

12 Ethernet-to-DeviceNet Linking Device
Rockwell Automation Publication 1788-IN055C-EN-P - September 2011
Configure the Linking Device IP Address
Several methods may be used to set the IP Address. These methods include the
following:
• IP address configuration DIP switch
• DHCP protocol
• Web page
• RSLogix 5000 software, version 13 or later), and 1788-EN2DN Linking
Device, revision 2.
x or later
Setting the IP Address with the Configuration DIP Switch
A configuration DIP switch on the end of the linking device lets you set the IP
address. If the configuration DIP switch is set to 1 (in the up position, as shown
in the following figure), when power is applied to the switch, the value of the
switch creates the IP address of 192.168.1.1.
IP Address Configuration DIP Switch
IMPORTANT The numbers that appear above the switches on the DIP switch do not
correspond to bit locations in the address value. The numbers on the switch
are opposite the address value bit locations; for example, bit 0 is set by
switch 8.
ON 2 3 4 5 6 7 8 1
ON 2 3 4 5 6 7 8 1
31421-M