Rockwell Automation 1788-EN2DN Ethernet-to-DeviceNet Linking Device - Manual (Page 8)

8 Ethernet-to-DeviceNet Linking Device
Rockwell Automation Publication 1788-IN055C-EN-P - September 2011
Optional Software
RSLogix™ 5000 software, version 13 or later.
Installing and Configuring the Linking Device
Follow these steps to install the linking device (described in the sections that
follow).
WARNING: If you connect or disconnect the communication cable with power
applied to this module or any device on the network, an electrical arc can occur. This
could cause an explosion in hazardous location installations.
If you connect or disconnect wiring while the field-side power is on, an electrical arc
can occur. This could cause an explosion in hazardous location installations. Be sure
that power is removed or the area is nonhazardous before proceeding.
When you change switch settings while field-side power is on, an electrical arc can
occur. This could cause an explosion in hazardous location installations.
Be sure that power is removed or the area is nonhazardous before proceeding.