Rockwell Automation 1788-EN2DN Ethernet-to-DeviceNet Linking Device User Manual
Page 23
Advertising
Ethernet-to-DeviceNet Linking Device 23
Rockwell Automation Publication 1788-IN055C-EN-P - September 2011
9.
Enter the desired MAC address or data rate, then click Apply.
10.
Click Close.
11.
Restart RSNetworx for DeviceNet software and go online.
IMPORTANT
The linking device will automatically reset if a new MAC ID is entered. If only
the communication rate is changed you must cycle power to the linking
device before the new communication rate will take effect.
When the MAC ID is changed, the linking device’s I/O configuration is cleared.
TIP
If you are using the linking device as a network gateway, you may need to
restart RSNetWorx for DeviceNet software before continuing.
Advertising