Rockwell Automation 1788-EN2DN Ethernet-to-DeviceNet Linking Device User Manual
Page 9
Ethernet-to-DeviceNet Linking Device 9
Rockwell Automation Publication 1788-IN055C-EN-P - September 2011
Connect the Linking Device to the EtherNet/IP Network
Connect the EtherNet/IP network cable to the RJ45 port on the end of the
linking device.
ATTENTION: This product is grounded through the DIN rail to chassis ground. Use
zinc plated yellow-chromate steel DIN rail to assure proper grounding. The use of
other DIN rail materials (for example, aluminum or plastic) that can corrode,
oxidize, or are poor conductors, can result in improper or intermittent grounding.
Secure DIN rail to mounting surface approximately every 200 mm (7.8 in.) and use
end-anchors appropriately.
DeviceNet Connection
Power Connection
Configuration DIP Switch
RJ45 Port (EtherNet/IP Connection)
31480-M