Rockwell Automation 1788-EN2DN Ethernet-to-DeviceNet Linking Device - Manual (Page 16)

16 Ethernet-to-DeviceNet Linking Device
Rockwell Automation Publication 1788-IN055C-EN-P - September 2011
Setting the IP Address Using By Using the Web Page
The EtherNet/IP address can also be configured using the IP Configuration web
page on the linking device, as shown in the following figure.
The IP address can be set with the web page only if the linking device already has
a valid IP address. Typically, you can do this by using the DIP switch to force the
linking device to use a temporary IP address after you cycle power. Follow these
steps to configure the IP address with the web page.
1. Browse to the linking device by entering the temporary IP address in
your web browser’s address bar and click Enter.
2. In the left pane, click IP Configuration.
You see the Enter Network Password dialog box.
3. In the Username field, enter Administrator.
IMPORTANT Because the DIP switch setting overrides other IP address configurations, be
sure to set the DIP switch to the 0 position before continuing.