Rockwell Automation 1788-EN2DN Ethernet-to-DeviceNet Linking Device - Manual (Page 44)

44 Ethernet-to-DeviceNet Linking Device
Rockwell Automation Publication 1788-IN055C-EN-P - September 2011
CIP Link Status Indicator
The CIP Link status indicator indicates bridged and gateway activity between
EtherNet/IP and DeviceNet networks. The status indicator will flash green
when a CIP message is bridged from EtherNet/IP to DeviceNet networks. The
status indicator will be solid green if an EtherNet/IP I/O connection is active.
Using Diagnostic Web Pages
Status
The Status page displays the linking device identification information, current
status, and IP configuration. The module status is updated approximately every
2.5 seconds.
Active Nodes
The Active Nodes page indicates which DeviceNet nodes are currently
configured as slaves to the linking device’s DeviceNet scanner. Each node that is
configured as a slave will be displayed with ‘Active’ next to the node’s MAC ID.
Solid red Address conflict The module’s IP address is already in use by
another module.
Flashing Red Connection time-out One or more of the connections in which this
module is the target has timed out. This state is
only left if all timed out connections are
re-established or if the module is reset.
Red,Green
alternate flashing Self test A self-test of the module is in progress.
Ethernet Network Status Indicator States
Indicator Status Description