Bendix Commercial Vehicle Systems SMARTIRE TPMS OPERATORS MANUAL - Manual (Page 17)

17
3.2.2 Communications Setup
To setup communications over J1939:
1. Connect the Gateway connector on the SmarTire
™
harness to the vehicle’s Gateway.
2. Connect the J1939 Diagnostic port of the harness to your PC-to-CAN adaptor (i.e.
RP1210A).
3. Connect the harness’ VIN1 and GND1 wires to 12-24VDC.
4. Apply power to the hardware.
5. Run
SmarTire
™
Diagnostic Tool.exe on your PC.
6. Select your J1939 Adaptor on the menu bar. If it doesn’t appear in the Adaptor drop-
down list, ensure you have the appropriate drivers installed on your computer.
7. Click ‘Connect J1939’ to start the interface communicating over J1939.