Bendix Commercial Vehicle Systems SMARTIRE TPMS OPERATORS MANUAL - Manual (Page 30)

30
Message Cause & Solution
ERROR – RE-ENTER
VALUE Cause: The value being entered was not accepted due to increased
network traffic.
Solution: The user will be returned to the original menu upon pressing
any button in order to re-enter the value.
SENSOR
DIAGNOSTIC
TROUBLE CODE -
Dual Light Display &
Trailer Lamp Only
(lower light flashes
twice followed by a 5
second pause,
repeated) Cause: No signal has been received from a sensor for 35 minutes as a
result of a broken sensor or wireless reception issue. If the diagnostic
trouble code is intermittent, it is usually caused by inconsistent
reception. If the diagnostic trouble code is consistent after the vehicle is
driven, the sensor may be broken.
Solution: This problem is frequently due to the removal of the tire with
the programmed sensor. If the correct tire is still installed, reception
quality and/or sensor functionality must be diagnosed. Contact your
authorized dealer for assistance.
SYSTEM
DIAGNOSTIC
TROUBLE CODE -
Dual Light Display &
Trailer Lamp Only
Cause: Improper programming, program corruption, electrical problems,
and component failures can cause a system diagnostic trouble code.
Solution: Contact your authorized dealer for assistance if this diagnostic
trouble code persists for more than an hour of driving the vehicle.
5.6 SETUP MODE – FOR USE WHEN SMARTIRE
™
DIAGNOSTICS SOFTWARE IS NOT
AVAILABLE
SmarTire
™
TPMS can be configured by accessing its Setup Mode. Follow the steps below to
access the Setup Mode:
1. The Setup Mode can only be accessed from the TPMS Ready screen. Press the center
button repeatedly until the TPMS Ready screen is displayed (screen shows TPMS Ready
and tire icon).
2. Press and hold the center button for two seconds and the display will show a password
entry screen. NOTE: If the password function has not been activated, the setup mode will
be entered directly.
3. To enter a password, press the left button to scroll the first digit from 9 to 0. When the
correct digit is displayed, press the right button to move to the next digit in sequence.
4. Repeat step three until all four digits are entered correctly and then push the right button
to enter the password. If the password is correct, the display will enter Setup Mode. If the
password is incorrect, the display will indicate that the wrong password was entered and
return to the password entry screen.