Bendix Commercial Vehicle Systems SMARTIRE TPMS OPERATORS MANUAL - Manual (Page 38)

38
5.6.9 Changing the Password
A four digit, numerical password is required to enter the Setup Mode. The default password is
‘0000’. Follow the instructions below to customize the password:
1. Enter the Setup Mode using the steps outlined in section 5.6.
2. When in the Setup Mode, press the left button until “Change Password” is highlighted.
Then press the right button to select the function.
3. The display will then show “Enter Password” and four digits. Before a new password can
be set, the original password must be confirmed. To enter a password, press the left
button to scroll the first digit from 9 to 0. When the correct digit is displayed, press the
right button to move to the next digit in sequence.
4. Repeat step three until all four digits are entered correctly and then push the right button
to enter the password.
5. If the password that was entered was correct, the display will show “Enter New
Password” and four digits. Again, press the left button to scroll the first digit from 9 to 0.
When the desired digit is displayed, press the right button to move to the next digit in
sequence.
6. Repeat step five until all four digits are entered as desired and then push the right button.
7. The screen will then prompt to “Save Password” with a choice of YES or NO. If the
password entered is correct, press the right button to save it as the new password. Press
the left button or the center button to reject the password and enter a new one.
8. Press the center button once to exit to the Setup menu and again to exit Setup Mode.