Bendix Commercial Vehicle Systems SMARTIRE TPMS OPERATORS MANUAL - Manual (Page 45)

45
3. Locate the ABS ECU power supply line or junction box
on the trailer chassis. Plug the ABS Power Splice from
the trailer harness into the power supply line at P11
and P12 (see wiring harness: Trailer – 260.297/98). If
no ABS breakout is present, route line F of the
trailer harness directly into the junction box via a 5
Amp fuse connector. This may require cutting line F
before P11/12.
For more information, please refer to the circuit
diagram in your vehicle specific manual.
4. Plug the TPMS Indicator Lamp output P13 into the existing trailer lamp (see wiring
harness: Trailer – 260.297/98). If an auxiliary lamp is not already installed, refer to the
Bendix optional trailer indicator lamp part number 200.0188. Position the lamp alongside
the trailer in an area that is easily viewable from either the left or right rear view mirror.
Use the mounting hardware that is supplied with the Lamp module to secure it on the
trailer. Run additional 18 gauge cable (not included) from the lamp output of the
SmarTire
™
harness to the location of the lamp on the trailer.
5. Connect P1 (see wiring harness:
Trailer – 260.0297/98) to the
receiver module and secure the
diagnostics port P8 and P9
(optional) in a convenient location
along the trailer chassis using a
medium sized P-clamp around the
back of the connector (not
included).
6. Interface the SmarTire
™
Diagnostics Software Tool to port P8 (see wiring harness: Trailer
– 260.297/98) to program the trailer’s Wireless Gateway Receiver. Refer to the
diagnostics tool manual for additional setup information.