Bendix Commercial Vehicle Systems SMARTIRE TPMS OPERATORS MANUAL - Manual (Page 19)

19
2. To specify how many axles are present on the vehicle, click on the check mark after the
last axle on your vehicle. Darkened axles and tires are active and can be programmed.
Grayed out axles and tires are disabled.
3. Next, ensure that all active axles have the correct number of tires assigned. Use the
‘Dual Wheel’ check box under each axle to configure this. Note: Steps two and three
must be carried out each time the software is restarted, regardless of the saved
configuration in the receiver.
4. When you’ve completed setting up the vehicle’s axles, adjust the CIP values for each
axle. If you would like to change the units being displayed, click the ‘Units of Measure’
button on the left side of the window (or press ALT-6).
5. Now we will check the Alert levels to ensure they are the right values for your system.
Click the ‘System Parameters’ button (or press ALT-4). Bendix recommends that you
use the default values that came programmed with the Wireless Gateway, but you can
change them here if desired.
6. Click the Axle Configuration button (or press ALT-1) to return to the Axle Configuration
screen.