Bendix Commercial Vehicle Systems SMARTIRE TPMS OPERATORS MANUAL - Manual (Page 44)

44
for a better fit. For systems using a dual-light display, identify connector P7 in the vehicle
wiring harness diagram - 260.0275 (not included under section 5 of the SmarTire
™
manual). Use a spare rocker switch on the dashboard to situate the dual-light display.
4. Connect P5 of the Light vehicle wiring harness to the back of the 2" SmarTire
™
Display /
P7 to the back of the dual-light display. Locate the Display power and ground line on the
harness diagram (see back of 6-pin Display connector, printed on wire) and plug them
into a spare outlet on the vehicle’s fuse box with a 5 Amp fuse protection. Ensure that
the ground line is properly connected – it is possible to use the same ground point as in
Step 2.
For more information, please refer to the circuit diagram in your vehicle specific manual.
6.3.1 Trailer Specific Installation
1. For installations on commercial trailers, position the receiver on the centerline of the
trailer if possible, between the two rear axles (if 3-axle trailer, position near center axle)
and within a clear line of sight to the trailer’s wheels. Using the integrated bolt holes and
two ¼ -20 (M6X1) Flange Head Cap screws, attach the receiver to a frame bracket or a
mounting plate and torque to 7-10 FT/LBS (13 Nm).
2. Attach supplied antenna to the external TNC antenna port.