Bendix Commercial Vehicle Systems SMARTIRE TPMS OPERATORS MANUAL - Manual (Page 34)

34
5.6.5 Display Contrast
Follow the instructions below to modify the contrast of the display:
1. Enter the Setup Mode using the steps outlined in section 5.6.
2. When in the Setup Mode, press the left button until “Screen Contrast” is highlighted. Then
press the right button to select the function.
3. The display will then show “Contrast Adjust” and a bar indicating the level of contrast.
Press the right button to increase the contrast and the left button to decrease the
contrast. Each time the right button is pushed, an additional box on the contrast bar will
darken and the contrast will increase. Each time the left button is pushed, one less box
on the contrast bar will be dark and the contrast will decrease.
4. When the desired level of contrast is attained, press the center button once to save the
setting. Press the center button again to exit Setup Mode.
5.6.6 Audible Alert Settings
SmarTire
™
TPMS has an optional Audible Alert (part number 255.0077) to compliment the Visual
Alert light that is triggered during a tire pressure or temperature alert. If the system was installed
with the audible alert module, the alert can be disabled and customized by the user. Follow the
instructions below to modify the audible alert settings:
1. Enter the Setup Mode using the steps outlined in section 5.6.
2. When in the Setup Mode, press the left button until “Buzzer” is highlighted. Then press
the right button to select the function.
3. The display will then show a “Startup” setting and an “Alarm” setting along with their
preset values. Press the left button to scroll between the two programmable functions
and the right button to select the function for programming.
4. Once selected, press the down button to scroll between setting the function to ON or
OFF. When the “Startup” function is set to ON, SmarTire
™
TPMS will make a noise on
start up. When the Alarm function is set to ON, the system will emit an audible alarm
when an alert is triggered. When the desired value is displayed, press the right button to
select it.
5. Repeat steps 3 and 4 until all settings are correct. To save the new settings, press the
center button once.
6. Press the center button again to exit Setup Mode.