Bendix Commercial Vehicle Systems SMARTIRE TPMS OPERATORS MANUAL - Manual (Page 33)

33
2. When in the Setup Mode, press the left button until “Axle Params” is highlighted. Then
press the right button to select the function.
3. The first axle will then be displayed along with its CIP value. Press the left button to scroll
to each programmed axle on the vehicle. Each time the left button is pressed, the axle
designator will change to the next axle in sequence and the CIP for that axle will be
displayed. Press the right button to select the axle for programming.
4. Press the left button to increase the number or the right button to decrease the number
until the desired value is shown. Hold down either button to quickly increase or decrease
the number. When the desired value is displayed, press the center button to save the
value.
5. Repeat steps 3 and 4 to continue customizing the CIP values for each axle until all axles
are programmed correctly.
6. To save the changes and exit the “Axle Params” function, press the center button once.
Press the center button again to exit Setup Mode.
5.6.4 Altitude Compensation (Optional)
SmarTire
™ TPMS can be made to compensate for the pressure changes caused by elevation. To
compensate for elevation, the system uses an ambient pressure sensor. The primary use of this
feature is for off-highway equipment located in elevations other than sea level for extended
periods of time. Unless an ambient pressure sensor has been installed on the vehicle, the Altitude
Adjust setting should be set to “OFF”. Follow the instructions below to modify the Altitude Adjust
setting:
1. Enter the Setup Mode using the steps outlined in section 5.6.
2. When in the Setup Mode, press the left button until “Altitude Adjust” is highlighted. Then
press the right button to select the function.
3. The display will then show “Altitude Comp” with either ON or OFF highlighted. Press
either the left or right buttons to scroll between the ON and OFF setting.
4. When the desired setting is highlighted, press the center button once to save the value.
Press the center button again to exit Setup Mode.