Metrohm NIRS Analyzer PRO User Manual
Page 27
Advertising
▪▪▪▪▪▪▪
25
4.
Press each tab above the wire to be
removed, and pull the wire directly
outward.
NOTE: Verify that power is off before
performing this operation.
5.
Gently loosen the cable gland over the
existing AC mains cable. Use a 22 mm
(approx 7/8”) open-end wrench.
NOTE: This nut is easy to loosen before
removal of Tri-clamp. Do not fully
remove the nut at this point.
6.
Remove the Tri-clamp holding the cable
input header. Save clamp for re-use.
7.
Continue to loosen the gland nut until it
separates from the cable seal.
Advertising