Metrohm NIRS Analyzer PRO User Manual
Page 41
▪▪▪▪▪▪▪
39
4.
Vision asks to create a Project database
as shown. If this location is acceptable,
click “OK”.
As a rule it is best to use the default
location, unless there is an over-riding
reason to use another location.
5.
Vision opens a screen for configuration
of data sources. This enables
communication with the instrument
through Vision.
Highlight “NIRSystems DDA Analyzer
PRO Instrument Driver” and click
“Configure”.
6.
Select and highlight the instrument with
the correct chassis ID number.
If there is only one instrument on the
network, it will be shown by default, as
shown at right.
Click “OK” to return to the previous
screen. Then click “OK” again. This sets
the communication channel to the
Analyzer PRO instrument.
7.
Vision prompts for connection to the
instrument. Click on “Acquire new Data”
to connect.