Metrohm 750 Autosampler User Manual
Page 40
3.8 Remote control
750 Autosampler
37
Select Data Bits
8
5,6,7,8
Entry of data bits
Entry of data bits for the RS232 interface. The value entered
here must also be set on the external controller. After the
data bits have been confirmed with <ENTER> the following
display appears:
Select Stop Bits
1
1,2
Entry of stop bits
Entry of stop bits in bits/s for the RS232 interface. The value
entered here must also be set on the external controller. After
the stop bits have been confirmed with <ENTER> the fol-
lowing display appears:
REMOTE MODE
RS-232
Instrument in remote control mode
The Autosampler 750 is completely controlled by the com-
puter connected to the RS232 interface. The Autosampler
remains in this condition until it is switched to normal opera-
tion by the controller or the <REM/LOC> key is pressed.
Remote control via the RS232 interface is carried out with the
commands described in the following table.