Metrohm 750 Autosampler - Manual (Page 41)

3 Operation
750 Autosampler
38
Summary of the remote control commands
Command Description
@GTV ###
@LDL #
@VLV LD/INJ
@RNP
@RVN
@RVP
@RDX
@RDY
@RDZ
@BZR $$$
@AUX 1 ON/OFF
@MSG ## "$$$"
@LOC
Go to vial position ### :
0 Rest position at left front
1
…
128
Vial position on sample tray
Fill sample loop:
The transfer needle is lowered to position # (1 … 4).
Switch injection valve:
LD LOAD (switch injection valve to FILL position)
INJ INJECT (switch injection valve to INJECT position)
Read needle position:
The position (1 … 4) is put out.
Read vial number:
The position (1 … 128; HOME) is put out.
Read injection valve position:
The position (LOAD, INJECT) is put out.
Read x position:
The x position (0 … 760) is put out.
Read y position:
The y position (0 … 1000) is put out.
Read z position:
The z position (0 … 46) is put out.
Trigger acoustic signal $$$:
CLK single short acoustic signal
ERR single long acoustic signal
ALM triple slow acoustic signal
PNC
repeated slow acoustic signal
ON
continuous signal
OFF switch off acoustic signal ( PNC , ON )
Set contact closure 1 ("T1") on or off.
Display at position ## (1
… 80; 1 … 20 = 1 st line; 21 … 40 = 2 nd line;
41 … 60 = 3 rd line; 61 … 80 = 4 th line) on the LCD display the message
"$$$...".
Return to normal operation (LOCAL).
# = digit 0 … 9; $ = any character