ADS Environmental Services Model 4000 530017 A0 - Manual (Page 119)

C-2 ADS Model 4000 Manual
7. Install the replacement I/O cable (part # 103197B) for external
power into the empty I/O hole. Insert the connector up into the
hole through the bottom of the monitor lid, making sure the O-
ring seats properly against the chassis. Hold the connector in
place with one hand to keep the O-ring in place while
tightening the connector nut.
8. Connect the new I/O cable to the processor board in the
following way:
Connect the shortest wire to the processor board at P4
(upper-right).
Connect the long gray wire with the two-position orange
connector to the processor board at P7 (bottom-left).
Connect the long red wire with the yellow inline fuse
holder to the processor board at P6 (bottom-center).
Secure the excess wire in the plastic cable clip located
below the processor board.
Note: The inline fuse on the red wire protects the
monitor from oversurges, short circuits, and reverse
polarity. Therefore, do not defeat the fuse.
Ports for wiring external power I/O cable