ADS Environmental Services Model 4000 530017 A0 - Manual (Page 68)

Monitor and Sensor Installation 3-45
Connecting the Sensors to the
Monitor
After attaching the sensors to the ring, connect the sensor cables to
the appropriate ports on the top of the monitor. The ports are
labeled to identify the appropriate connection for each sensor.
Connect the sensor cables to the monitor ports in the following
way:
1. Place the monitor in an upright position to view the monitor
connector ports.
FOR TEST ONLY
Cable connector ports
2. Visually inspect each sensor connector and monitor connector
port for damaged or broken pins. Replace a monitor or sensor
with defective ports or connectors.
3. Visually inspect each sensor and monitor connector port for
debris and moisture. Clean off any debris, and dry any surface
moisture. Compressed air is useful for removing moisture
from the inside of the connectors or ports (pin and socket
surfaces).
4. Verify that the waterproof seal is present inside each connector
port. The bright orange, rubber seal should sit at the bottom of
the connector port with the pins protruding through the seal.