Trees and shrubs – Baseline Systems BaseStation 3200 V12 User Manual

Page 13

Advertising
background image

BaseStation 3200 Advanced Irrigation Controller Manual

If you want to install a sensor in newly seeded turf grass, follow the installation instructions and

bury the sensor at the proper depth. Baseline recommends that you water according to an

appropriate timed schedule until the grass has rooted sufficiently (typically 60 to 90 days) before

enabling a sensor based watering strategy. After the grass has rooted, you can convert the primary

zone to a sensor based watering strategy.

Likewise, newly installed sod has very shallow roots. Water the new sod on an appropriate time

schedule until it has rooted sufficiently to enable a sensor based watering strategy (typically 30 to

60 days).

Trees and Shrubs

If trees and shrubs are watered separately, a moisture sensor is an excellent tool to maintain their

health and beauty. Typically, multiple trees are watered by the same zone. If so, choose an average

tree, and install the biSensor in the top 1/3 of the root zone of the tree.

biSensor in the top 1/3 of the root zone of an established tree

Angling the sensor can monitor a deeper soil profile for trees that have deep root structures.

If the tree is watered with drip emitters or bubblers, install the sensor in a location that is not

directly under the emitter or bubbler to avoid partial watering of the whole root zone of the tree. If

multiple emitters are used for a single tree, a good rule of thumb is to install the sensor roughly

half way between two emitters and as much inside the root mass of the tree as possible without

damaging the roots.

Note: Root depth and water requirements for trees and shrubs vary much more greatly than for

turf. Consult an experienced Arborist or Master Gardener for specific guidelines for watering trees.

Most trees are watered along with turf in commercial landscapes. In this case, Baseline

recommends that you install biSensors in the turf areas and that you adjust the default run times of

zones with trees to ensure water application to 12 inches or whatever is required to optimize tree

health.

Page 7

Advertising