Baseline Systems BaseStation 3200 V12 - Manual (Page 46)

BaseStation 3200 Advanced Irrigation Controller Manual
4. Press the Next button to move to the Water Time field.
 To change the value in the hours place, press the + button.
 To change the value in the minutes place, press the Next button, and then press the + or
– button.
Tip: Let the controller calculate the cycle time and soak time settings for you. Press the Next
button to move to the minutes placeholder in the Soak Time field, and then press the Back
button. The controller divides the time in the Water Time field by 3. This value is used for the
cycle time and the default soak time is 30 minutes.
5. Press the Next button to move to the Cycle Time field. If you are using soak cycles for this
zone, the cycle time defines the duration of each watering cycle interspersed with soak times.
6. Press the Next button to move to the Soak Time field. If you are using soak cycles for this
zone, the soak time defines the duration of each soaking cycle interspersed with watering
times.
7. Press the Next button to move to the Flow field. If you know the gallons per minute flow for
this zone, you can press the + or – button to enter it in this field. You can also perform a Learn
Flow operation to update this field. Refer to Learning Flow by Zone on page 71.
8. Verify that the number displayed in the Program field in the upper-left corner of the screen
matches the program in which you want to set up the timed zone.
 If you want to set up the timed zone in a different program, press the Next button to
move to the Program field, and then press the + or – button to change the program
number.
 If you want to remove a zone from one program and assign it to a different program,
refer to Configuring Zone Settings on page 31.
9. Press the Next button to move to the Enabled field, and then press the + or – button to toggle
between YES and NO. Set the value to YES.
10. After you have configured the settings for the current zone, perform one of the following
actions:
 To configure another zone, press the Enter button until the number of the zone that you
want to configure displays in the Zone field at the top of the screen. Repeat steps 3 – 9.
 When you have finished making changes, turn the dial to the RUN position.
Page 40