Carlo Gavazzi WM5-96 - Manual (Page 13)

Programming WM5 96
The “S” (1) key is used to enter programming, confirm the selected or
modified data and go back to the previous data if pressed for at least
2 seconds. The “
” keys at N. 6 are used to scroll the menus and
modify the selected values/data. To modify the values proceed as fol-
lows: the “
” (2) key increases in a cyclical way the selected digit
from 0 to 9, to move to the next digit, use the “ ” (3) key, also in this
case the system is cyclical.
Example, enter the value 213: starting situation 000, press “ ” twice
to increase the number up to 2, then press “ ” to go on to the next
digit (on the right); the instrument displays 200, press “ ” once to
increase the number to 1, then press “ ” to go on to the next digit
(on the right); the instrument displays 210, press “ ” three times to
increase the digit to 3, press “S” to confirm the value. If you do not
want to confirm the value, but only to modifiy it, press the “
” key.
By means of a single command and only from the “P00” page, you
can carry out the reset of all the min. and max. values, the dmd and
dmd max values, the reset of all the logged events and of the alarms
with latch. To carry out this reset command you have to enter some
numeric codes: press the “S” key, the instrument displays the “
”
indication. Enter by means of the “ ” keys the following numeric
codes depending on the reset you want to carry out.
5784= reset of all the minimum and maximum values;
5785= reset of all the “dmd” and “dmM” (dmd max) values;
7239= reset of all the “events”;
9288= reset of the alarms with latch.
To access the programming menus from the measuring and display
phase, press the “S” key (only from the “P00” page), when the pass-
word “PASS?” is requested, enter the correct PASSWORD value by
means of the “
” keys, then confirm by pressing the “S” key
again. If the PASSWORD is correct (for all instruments the PASS value
when they leave the factory is “0”), the instrument will enter the main
menu.
To cancel the choice and go back to the measuring mode, press the
“S” key for at least 2 seconds.
Menu title.
Menu.
Scroll bar.
Firmware revision of the instrument.
Type of measuring analogue output being mounted on the instru-
ment. e
d
c
b
a
PASS?
Programming keypad
Resets
Access to programming
11
WM5-96 Instruction Manual
1 2 3
PASS ?
**********MMAAIINN MMEENNUU**********
RREEVV.. 11..44..22..66 ((AAVV55))
CHANGE PASSWORD
MODULES
SYSTEM
CT RATIO
0 000
PASS ? 0 000
123...
a
b c
d e
1
2
> 2s
Measure
> 2s
Measure
> 2s
Measure