Carlo Gavazzi WM5-96 - Manual (Page 39)

37
WM5-96 Instruction Manual
Programming WM5 96
This function allows to set the language to be displayed by WM5. Choose the
LANGUAGE function
(1) by means of the “ ” keys and confirm with “S”.
Then select the desired language by means of the “ ” keys and confirm
with “S”.
Selecting the SERIAL NUMBER function, the instrument displays the seri-
al number of the instrument. Select the function SERIAL NUMBER
(1) by
means of the “ ” keys and confirm with “S”.
Selecting the METER INFORMATION function, the instrument displays
the information relevant to the reference standard used by the instru-
ment. Select the function METER INFORMATION
(1) by means of the
“ ” keys and confirm with “S”. Choose the desired standard by
means of the “ ” keys and confirm with “S”.
Note: the selected standard is displayed in the Info pages too.
By turning the screwdriver anticlockwise to the end-of-stroke of the
relevant trimmer, as shown in the figure on the left
(a) , it’s possible to
lock the access to the programming of the instrument both from key-
pad and from serial communication. Moreover, after locking the key-
pad it will not be possible to carry out the reset commands any more.
However, it will be still possible to scroll all the display pages and the
relevant details.
Language
Serial number and
Meter Info.
Keypad lock, lock of access to pro-
gramming and reset menu
**********MMAAIINN MMEENNUU**********
RREEVV.. 11..44..22..66 ((AAVV55))
SERIAL OUTPUT
FILTER
CLOCK
LANGUAGE
**********MMAAIINN MMEENNUU**********
RREEVV.. 11..44..22..66 ((AAVV55))
USCITA SERIALE
FILTRO
CLOCK
LANGUAGE
ENGLISH
ITALIANO
DEUTSCH
FRANCAIS
1
2
> 2s
Measure
> 2s
Go back
Confirm
a
**********MMAAIINN MMEENNUU**********
RREEVV.. 11..44..22..66 ((AAVV55))
CLOCK
LANGUAGE
SERIAL NUMBER
METER INFO.
527 70000 T 0017
1
2
> 2s
Measure
EN
CAN
ANSI