Carlo Gavazzi WM5-96 - Manual (Page 41)

39
WM5-96 Instruction Manual
Panel cut-out and dimensions
5
m
m
5
4 1
2
3
Fixing, removing the modules and mounting the instrument to the panel
Sealing the instrument
Installing
Mounting and removing the modules: the different modules (input, output and power supply) have been designed
to be plugged in the available slots. To know in which slots they are to be mounted, refer to the table on the left. For
a correct assembling of the instrument, first plug the modules into the relevant slots, then as last operation plug in the
central module which can also be a blind module or an RS232 serial communication module. This module also locks
the other modules in the relevant slots. To remove the modules use a screwdriver with a flattened tip and move the
two fixing tabs to the side
(1) ; then remove the central module from its slot by pressing your thumb towards points (2)
and (5) . Finally extract the central module.
Panel mounting: insert the instrument (holding its front side) into the panel and fasten it (from the back) by fixing the
two lateral brackets being supplied
(a) to the appropriate location (b) , and then locking them by means of the two
screws supplied with the instrument (c) .
c
b
b
a
The special sealing kit, made by two plastic “cuneiform” devices (c) is
supplied with the instrument; these two devices will have to be insert-
ed as shown in the figure on the left
(a) , then the seal is to be placed
as indicated by the pointer (b) .
a b
1
24mm
c