Configure library: drives, Configure – Dell PowerVault TL4000 User Manual
Page 146
7.
Select Enable SSL for EKM to enable Secure Sockets Layer for the IBM SKLM
application.
8.
Select an Encryption method, from the pull down menu, for each logical
library.
v
Without an encryption license key, select None or Application Managed
Encryption
.
v
With an encryption license key, select Library Managed Encryption.
9.
Select an Encryption policy, from the pull down menu, for each logical
library.
v
Encrypt All
: This is the default policy. It encrypts all cartridges using the
default data keys specified in the key manager. This setting applies to all
drives in the TL2000/TL4000 logical library.
v
Internal Label - Selective Encryption
: Check your tape backup software
application documentation to see if this feature is supported.
v
Internal Label - Encrypt All
: Check your tape backup software application
documentation to see if this feature is supported.
10.
A primary and secondary key management server can be set for each logical
library. Each partition has its own Encryption and key management settings.
Maintaining primary and secondary key management servers are desired for
maximum availability of encrypted backup and recovery. These settings are
required for Library Managed Encryption only. Enter the EKM Server Setting
information.
v
Primary IP address (IPv4 or IPv6)
: Enter the IP address of the primary key
management server.
v
Primary TCP port
: After entering the Primary IP address, the library will
automatically set the value of the Primary TCP port.
v
Secondary IP address (IPv4 or IPv6)
: Enter the IP address of the secondary
key management server.
v
Secondary TCP port
: After entering the Secondary IP address, the library
will automatically set the value of the Secondary TCP port.
Note:
The Default Port for TCP (SSL disabled) is 3801. The Default Port for
SSL is 443. These values are the default values set by the library.
They can be changed depending on the user configuration but the
user has to make sure they match the IBM SKLM properties file.
Note:
If SSL is enabled the encryption host configuration will request a SSL
port instead of a TCP port. Review the IBM SKLM Knowledge Center
online at for instructions to locate the appropriate
port settings.
11.
Click Submit to apply the changes.
12.
Install the IBM SKLM application on your host. Refer to the IBM SKLM
Knowledge Center online for information on locating the appropriate IP address
and port.
Configure Library: Drives
This page allows you to modify the current ID assigned to a SCSI or Fibre Channel
drive. This page allows any drive in the library to be powered off by de-selecting
the check mark in the Power On box. The displayed information will vary
depending on the library model and drive type (SCSI, SAS, or Fibre Channel).
Table 5-12 on page 5-49 lists all available elements on this page. An "X" indicates
that the element displays for the specified drive type.
5-48
Dell PowerVault TL2000 Tape Library and TL4000 Tape Library User's Guide