Dell PowerVault TL4000 - Manual (Page 200)

Table 8-2. Sub error codes (continued)
73 Error during move sled to block.
80 Opening I/O slot failed.
81 Error during movement to I/O slot open position.
82 Error during moving back - sensor was found.
90 Movement to home position failed.
91 Elevator movement to home position failed.
92 Error during sled movement to rotation position.
93 Error during rotation to home or far position.
94 Sled movement to home sensor position failed.
95 Sled movement to transport position failed.
99 Error during rotation movement to rotation min position
A0 Movement of I/O slot failed.
A1 Sled movement to sensor failed.
A2 Sled movement to rotation position failed.
A3 Elevator movement to home position failed.
A4 Error during rotation to far position.
A5 Sled movement to I/O slot position failed.
A6 Error during elevator movement to position
A7 Error during mailslot detection
B0 EEPROM on robotics controller not accessible or error during Read/Write operation
B1
Save/restore configuration settings: not enough internal memory available for creating the file and
restoring the file respectively
B2 Save/restore configuration settings: restore buffer corrupted, checksum calculation failed
B3 Save/restore configuration settings: data base field corrupted
B4 Save/restore configuration settings: invalid personality
B5 Save/restore configuration settings: invalid file
LIBRARY
81 Drive wake up failed
88 Error accessing slot status
90 Accessor load not reached Cartridge Present sensor
91 No activity after Load command
92 Timeout while loading tape
93 No activity after load command
94 Timeout drive Unload
95 Drive terminated unsuccessfully
96 Tape not ejected at robot unload
8-10 Dell PowerVault TL2000 Tape Library and TL4000 Tape Library User's Guide