Dell PowerVault TL4000 - Manual (Page 228)

Note: The gray markers show where conductive tape is placed.
i. Push the black tab back underneath the drive sled. When inserted properly,
only the handle of the tab is visible.
2. Power ON the replacement library enclosure.
a.
If power ON is successful,
1)
After power up, the Ready/Activity LED ( 1 in Figure 10-20 on page
10-22) turns ON.
a)
If this message is displayed after the library powers ON, follow the
instructions.
[New library detected.]
[Please remove power and insert LCC from old library]
[ok]
2) Power OFF the replacement library enclosure.
3) You must power down, and remove the CRU LCC. Then, replace it with
the original LCC to have VPD transferred from the original LCC to the
new chassis.
4) Proceed to “Swapping Power Supplies.”
b. If power ON is not successful,
1)
The Error LED ( 4 in Figure 10-20 on page 10-22) turns ON.
2) Power OFF the replacement library enclosure.
3) Contact technical support for instructions.
Swapping Power Supplies
1. Unplug the power cord from the power source then from the replacement
library enclosure if this was not done previously (see “Installing your drive in
the replacement library enclosure” on page 10-16).
2U Library 4U Library
a77ug20
3
Figure 10-17. Drive sled taping diagrams
10-18 Dell PowerVault TL2000 Tape Library and TL4000 Tape Library User's Guide