Dell PowerVault TL4000 - Manual (Page 202)

Table 8-3. Warning events (continued)
48 SCSI: drive type not supported in this
library Check whether a version of firmware is available that
supports this drive type. For a list of supported drives, refer
to “Ultrium Tape Drives” on page 1-9.
49 SCSI: incompatible magazine, magazine
not accessible
Check your configuration settings.
4A SCSI: source not ready
Complete move process and retry operation.
4B SCSI: destination source not ready
4C SCSI: library controller busy Complete process and retry operation.
4D SCSI: Cannot make reservation
Refer to your host application documentation for problem
determination information.
4E SCSI: invalid slave robotic controller
request
4F SCSI: robotic axes/motors aren't
initialized Check robotics status. Refer to “Isolating a Library
Controller Card vs. Accessor Enclosure Problem” on page
7-10.
50 SCSI: cartridge belongs to another
partition
Check application software.
51 Incompatible medium Check the compatibility of media and drive generation.
52 All slots full, no movement possible Remove a cartridge to make a move possible.
53 All slots empty required for wellness test Fill up required slots before the wellness test is started.
54 SCSI: failure in LME interface
1. Check your Encryption configuration.
2. Run Key Path Diagnostics.
3. Refer to the IBM SKLM Knowledge Center online for
information.
55 SCSI: invalid license key entered Reenter license key. If problem persists, refer to technical
support.
58 Recovered Error: SCSI parity error
No user action is required.
59 Recovered Error: Error log overflow
5A Illegal request, downgrade prohibited Disable encryption for firmware downgrade.
5B Incompatible medium generation Replace incorrect cartridges.
5C Illegal request, downgrade that is
prohibited because of incompatible
network stack
Change network settings to IPv4 only before downgrading
firmware.
5D Illegal request, wrong drive FW for drive Obtain correct drive firmware image.
5E Full height drive in illegal position Check correct Drive position.
60 Cleaning cartridge installed Complete the cleaning process and retry the operation.
61 Cleaning failure. Cleaning process could
not be performed
1. Verify that autoclean is enabled.
2. Check for an expired cleaning cartridge and replace if
necessary.
3. Refer to “Configuring I/O Stations and Reserving Slots”
on page 5-67.
62 Cleaning cartridge expired Replace cleaning cartridge.
63 Invalid cartridge. Drive rejected the data
cartridge as invalid
1. Verify that the correct cartridge is being used. Refer to
“Cartridge Compatibility” on page 6-3.
2. Refer to “Identifying a Suspect Cartridge” on page 7-12.
64 Invalid cleaning cartridge. Drive rejected
the cleaning cartridge as invalid
8-12 Dell PowerVault TL2000 Tape Library and TL4000 Tape Library User's Guide