Rack kit a mounting hardware – Dell PowerVault TL4000 User Manual
Page 61
a.
Rack Kit A: The following parts make up Rack Kit A.
v
Packaged in cardboard material:
– 2 rails (not shown) See Figure 4-9 on page 4-9 for a graphic of the rails.
– 2 mounting brackets ( 1 in Figure 4-6)
v
Packaged in the small bag with no label:
– 1 Torx wrench ( 5 in Figure 4-6)
– 2 anchors ( 4 )
– 2 countersunk screws for securing the anchors ( 6 )
– 2 small countersunk screws for securing the tops of the mounting
brackets ( 7 )
– 2 large screws to secure the mounting brackets to the rack ( 8 )
v
Packaged in the small bag with "Round Hole" on the label: 9 screws to be
used on racks with round holes. ( 2 )
v
Packaged in the small bag with "Square Hole" on the label: 9 screws to be
used on racks with square holes. ( 3 )
Note:
Eight (8) screws are needed for the installation. One additional screw
is provided for security.
4
a77ug275
1
3
2
8
5
6
7
Figure 4-6. Rack Kit A mounting hardware
Chapter 4. Installation and Configuration
4-7