The configure library: date and time screen – Dell PowerVault TL4000 User Manual
Page 87
v
User (if enabled)
v
Superuser (if enabled)
v
Admin
v
Service
Note:
Only one password can be set for each Role.
4.
Enter the New Password . The password has a maximum of 10 characters (A-Z,
a-z, 0-9, @, <hyphen>, <space>, <period>).
5.
In Repeat Password, enter the new password again.
6.
In Support Name, enter the name of the person that will be able to offer the
user help with the library.
Note:
Only one support person can be configured for the entire tape library.
The support person may or may not be one of the user, superuser, or
admin account holders.
7.
In Support Phone, enter the phone number of the person that will be able to
offer the user help with the library.
8.
In Support Email, enter the email address of the person that will be able to
offer the user help with the library.
9.
Click one of the following:
v
Refresh
- to update the current screen.
v
Submit
- to apply the changes made to the screen.
Entering Date and Time using the Web User Interface
1.
Click Configure Library > Date & Time in the left navigation pane.
2.
Enter the current Time using the HH:MM:SS 24-hour format.
3.
Enter the current Date using the MMDDYYYY format.
4.
Click one of the following:
v
Refresh
- to cancel all of your entries and leave the settings as they were.
v
Submit
- to apply the changes made to the screen.
Configuring Logs and Traces using the Web User Interface
This function is not available on the Operator Control Panel.
1.
Click Configure Library > Logs & Traces in the left navigation pane.
a77ug0
61
Figure 4-35. The Configure Library: Date and Time screen
Chapter 4. Installation and Configuration
4-33