Dell PowerVault TL4000 User Manual
Page 85
After the Submit button has been clicked, depending on the
changes made, you will either be disconnected and need to login
again or reboot the library.
Clicking the Refresh button will refresh the page and any changes
made will not be retained.
2.
Select a Protocol Stack - Choose IPv4 only, IPv6 only, or Dual Stack IPv4 &
IPv6
.
If you choose Dual Stack IPv4 & IPv6, you must be prepared to enter both
IPv4 and IPv6 IP addresses. The sections below will gray out depending on
the choices made here.
3.
Enter the Host Name.
Note:
The underscore (_) is not allowed as part of a host name.
4.
Enter the Domain Name.
5.
DNS Primary
- Enter the IP address of your primary DNS server.
6.
DNS Secondary
- Enter the IP address of your secondary DNS server.
7.
Enable SSL for Web
- If you desire to have SSL (Secure Sockets Layer)
enabled, place a check in this box.
Note:
If you get a security certificate alert when logging in to the Web User
Interface, you can install the certificate or allow an exception
(depending on the internet browser you are using). SSL is enabled
when the URL begins with https:// and some browsers will show a
lock.
8.
Ethernet Settings
- Ethernet Settings choices are: Auto (the default), 10
Mbit/Half
, 10 Mbit/Full, 100 Mbit/Half, 100 Mbit/Full. Please refer to
to determine the availability of manual Ethernet
settings in your library's firmware.
9.
Enter IPv4 settings (if applicable).
a.
Enable DHCP
- Click this item ON to have the IP Address of your library
automatically set by the DHCP server.
b.
Static Address
- Enter the assigned IPv4 address. The format of an IPv4 IP
address is a 32-bit numeric address written as four numbers separated by
periods.
c.
Network Mask
- Enter the assigned IPv4 Network Mask.
d.
Gateway address
- Enter the assigned IPv4 Gateway address. This address
allows access outside the local network.
10.
Enter IPv6 settings (if applicable).
a.
Enable DHCP
- Click this item ON to have the IP Address of your library
automatically set by the DHCP server.
b.
Enable Stateless Auto Config
- Stateless Auto config is ALWAYS on (not
defeatable).
c.
Static Address
- Enter the assigned IPv6 address. The format of an IPv6 IP
address is a 128-bit numeric address written as 8 groups of four numbers
separated by colons.
d.
Prefix length
- The default prefix length is set to 64, but can be set to any
length, depending upon the address used.
e.
Gateway address
- Enter the assigned IPv6 Gateway address. This address
allows access outside the local network.
11.
Click one of the following:
Chapter 4. Installation and Configuration
4-31