Dell 5100cn Color Laser Printer - Manual (Page 108)

Purpose:
To specify the TCP/IP settings. The change becomes effective after the printer is turned off and then on again.
Values:
IP AddressSetup AutoIP*
Automatically sets the IP address.
BOOTP
Uses BOOTP to set the IP address.
RARP
Uses RARP to set the IP address.
DHCP
Uses DHCP to set the IP address.
Panel
Enables the IP address entered on the operator panel.
IP Address
Sets the IP address allocated to the printer by using the keys on the operator panel.
Subnet Mask
Sets the subnet mask.
Gateway Address
Sets the gateway address.
Protocol
Purpose:
To enable or disable each item. The change becomes effective after the printer is turned off and then on again.
Values:
LPD On*
Enables the LPD port.
Off
Disables the LPD port.
Port9100 On*
Enables the Port9100 port.
Off
Disables the Port9100 port.
IPP* 1 On*
Enables the IPP port.
Off
Disables the IPP port.
SMB TCP/IP *1 On*
Uses TCP/IP for SMB.
Off
Does not use TCP/IP for SSB.
SMB NetBEUI
*1 On*
Uses NetBEUI for SMB.
Off
Does not use Net BEUI for SMB.