Appletalk – Dell 5100cn Color Laser Printer User Manual
Page 31
*1 The following are illegal characters: semicolon (;), colon (:), asterisk (*), question mark (?), period (.), comma (,),
yen mark (¥), back slash (\), double quotation ("), comparison symbols (< >), brackets ([ ]), operation symbols (+, =, or
~), pipe (|), slash (/), and space ( ).
NOTE:
The settings in the NetWare page will be valid only when NetWare or the printer is rebooted. Click the
Restart printer to apply new settings. button to apply new settings.
NOTE:
An optional multi protocol card is required to display the NetWare page.
SMB
Purpose:
To configure detailed settings for SMB.
Values:
Host Name
Specifies the host name up to 15 alphanumeric characters. The original setting will remain valid
if no input is made.
Workgroup
Specifies the workgroup name up to 15 alphanumeric characters. The original setting will remain
valid if no input is made.
Administrator
Name
Specifies the administrator name up to 20 alphanumeric characters. The original setting will
remain valid if no input is made. The default name is admin.
Administrator
Password
Specifies the administrator password up to 14 alphanumeric characters. The original setting will
remain valid if no input is made. The default password is password.
Confirm
Administrator
Password
Allows you to confirm the configured administrator password by re-entering the same password.
Maximum Sessions Displays the maximum sessions.
Unicode
Support
On Notifies the host name and workgroup name in Unicode characters.
Off Does not notify the host name and workgroup name in Unicode characters.
Auto Master
Mode
On Enable the Auto Master Mode.
Off Disable the Auto Master Mode.
Encrypt
Password
On Encrypts the password.
Off Does not encrypt the password.
Job Time-Out
Sets the timeout period from 60 to 3600 seconds.
Connection Time-
Out
Sets the connection timeout period from 60 to 3600 seconds.
NOTE:
The settings in the SMB page will be valid only when the printer is rebooted. Click the Restart printer to
apply new settings. button to apply new settings.
NOTE:
An optional multi protocol card is required to display the SMB page.
AppleTalk
Purpose:
To configure the detailed settings for AppleTalk.
Values: