Dell 5100cn Color Laser Printer - Manual (Page 28)

100BASE-TX
Full-Duplex
Selects 100Base-T Full-Duplex as the default value.
Current Ethernet
Settings
Displays the current settings of Ethernet.
MAC Address Displays the printer's MAC address.
Port
Settings
LPD Select the check box to enable the LPD.
Port9100 Select the check box to enable the Port9100.
IPP*
1 Select the check box to enable the IPP port.
FTP Select the check box to enable the FTP port.
SMB*
1 Select the check box to enable the SMB.
You can also configure the transport protocol to be used. TCP/IP and NetBEUI
can be selected simultaneously as the transport protocol.
NetWare*
1 Select the check box to enable the NetWare port.
AppleTalk* 1 Select the check box to enable the AppleTalk port.
E-Mail Alert Select the check box to enable the E-Mail Alert feature.
SNMP Agent Select the check box to enable the SNMP.
You can also configure the transport protocol to be used. UDP and IPX can be
selected simultaneously as the transport protocol.
IPX is only available when the multi protocol card is installed.
*1 An optional multi protocol card is required to use.
NOTE: The settings in the Port Settings item will be valid only when the printer is rebooted. When you change or
set this item, click the Restart printer to apply new settings. button to apply new settings.
TCP/IP
Purpose:
To configure the IP address, subnet mask, and gateway address of the printer.
Values:
TCP/IP
Settings
Host Name Specifies the host name up to 15 alphanumeric characters. The default name will
remain valid if no entry is made.
IP
Address
Mode
AutoIP Automatically sets the IP address.
DHCP Uses DHCP to set the IP address.
BOOTP Uses BOOTP to set the IP address.
RARP Uses RARP to set the IP address.
Manually
Set
Enables the IP address set in IP Address.
IP Address Sets the IP address allocated to the printer in the nnn.nnn.nnn.nnn format. Each
section of nnn.nnn.nnn.nnn is a value between 0 and 254. Note that values 127 and
224 to 254 are not valid for the first three-digits.
Subnet Mask Sets the subnet mask in the nnn.nnn.nnn.nnn format. Each section of
nnn.nnn.nnn.nnn is a value between 0 and 255. Note that 255.255.255.255 is invalid.
Gateway Address Sets the gateway address in the nnn.nnn.nnn.nnn format. Each section of
nnn.nnn.nnn.nnn is a value between 0 and 254. Note that values 127 and 224 to 254